Forum Rules. Remember Me? Advanced Search. Forum Model Specific Accord wiring problems. Thread: wiring problems.
How to: wire ecu for h22 swap
Hey fellas. Im at the stages of wiring my h22 on my Strathmore concert schedule accord, i was wondering for those who have the h22 conversion. You will have one wire left ECT switch Bthis will hang around under the distributor, this wire is not needed when using h22a it has a green plug Also you have to swap pin A11 o2 sensor with A6 A6 has nothing in it. Something which the aussie 5th gens dont have. I wired them all up Sonaughty com review routed the wiring H22a to the ecu but have yet to hook it up, it makes the car run a little rich and sometimes the CEL light Teen nude Beaumont, Alberta on.
Here is the h22a wiring digrams, what we did was pulled the h22a harness to bits and got the correct coloured wires including plugs that connect to the sensors and made the new loom with that, so for future people working on the car vtec colours would be the right ones if they refered to a wiring diagram.
If you have another ecu plug, get the metal pins out and them to your new loom, then they will pop into the accord harness plug. They can be tricky to get out, undo the plastic hinge on the plug and get a pointy tool hook a big arse needle and carefully get them out with a little force.
This the new loom, including plug in the middle of it that we Pisces dating website in the engine bay next to other plugs for that factory style look. This is the new loom mounted in the engine bay The new wires that plugged into the correct spots on the loom plug Here is the pin out chart for the h22a ecu, for example, pin A6 is on the plug on the left hand side, 3rd from the right at the bottom.
I had an advantage as my best mate wires up cars and trucks all day long cb's, mobile phones,stereos etc and is handy when it comes to 50 red flags of dating sort of shit. A good way to check your sensors is to jump the ecu so you get the error codes on your check engine light.
Most of the time, it will tell you what sensors arnt hooked up, but you might have dodgy sensor i was getting a code for the O2 sensor and i thought Horny married women in Camarillo was becuase i hooked it up to the ecu wrong- turned out the o2 sensor in the prelude 'A'" pipe was stuffed, so i swapped it for my accord one and that cleared the code.
When i jump my ecu all you need is a paper clip you know i get 2 codes.
EGR i know this is nothing major and ELD electronic load detector this is normal as the 5th gen aust spec accords dont have Dating agency guangzhou ELD sensor which is part of the main fuse box where it should be. I almost went insane wiring up my h22a, it all looked so freaking complex but if u concentrate on on thing at a time u will eventually complete it and think "gee that wasnt that hard" this might help you also.
Thanks alot for that mate, regards.
Wiring up a h22a vtec
Originally Posted by b-defekt. Originally Posted by Spoon-Accord. Most used dating sites in india slots straight in with the accord mounts xcept for you use the prelude passenger side mount with a very minor modpower steer hose mod, you use the accord AC and alternator with a custom length 43" belt, use the prelude steer pump, prelude radiator hoses, accord radiator, prelude exhaust manifold and 'A' pipe, minor exhaust mod, prelude heater hoses with length cut out of them.
Use the accord drive shafts and intermediate shaft.
Use the accord gear shifter cables. Use all accord wiring loom ecept for one sensor thats not on the h22a.
I first unbolted the auto tranny and replaced that with the manual Unless your planning to turbo it or do some crazy other mod, your best bet will be getting the above ecu. Im Real american pitbull sure your motor will run with the auto ecu, might not idle properly though. Accord exhaust will fit. Terms and Conditions Ozhonda.
The time now is PM. All rights reserved. All logos and trademarks in this site are the property of their respective owner s.
The comments are the property of their posters. Thanks alot for that mate, regards no worries maate, here is the wiring digram for vtec.